Bath waste and overflow set with bath filler in matte black design

For a perfect bathing experience, a reliable bath waste and overflow set is also a must. If you want something a little extra, opt for one where the overflow bath filler is included.

Safe water drainage

A bath waste set is used to safely drain the water from the bathtub. It is designed for all standard-sized bathtubs with a 52 mm outlet. An overflow kit with a bath filler is also included. It impresses not only with its performance but also with its matte black design.

Overflow filling

The overflow kit also includes a bath filler. This includes a Neoperl aerator, which is very easy to access and easy to clean. The advantage of the overflow filler is that the water does not run down the the bath and therefore does not leave any streaks. The advantage of this type of filler is a significant space saving (only the control knob remains visible) and minimising injuries such as bruises or scrapes caused by a standard bath drain.

No bad smell

The system also includes an odour trap with a swivel elbow and a diameter of 50 mm. It is heat and chemical resistant, longitudinally welded. The pressure resistance of the odour trap is 588 Pa and the thermal resistance is 95 °C.

Easy operation and maintenance

Operation of the waste is very easy, via a metal control knob with a matte black finish. Turn it to close or open the waste, using the bowden control. The control spindle is made of stainless steel. The waste set ensures a flow rate of 48.6 l/min. The overflow flow rate is 33.6 l/min. The overflow tubing is flexible. The length of the bath trap is 57 mm.

Complete bath waste set

• for filling the bath  using overflow filler
• for water drainage from the bath 
• for standard size bathtubs
• for bathtubs with Ø52 mm drain outlet

Properties

• bath overflow filler, trap and waste set
• Neoperl aerator – easy to access and replace if needed
• stainless steel control shaft
• water does not flow down the side of the bathtub and does not leave any stains
• takes up minimal bathtub space – only the control knob is visible
• easy installation with three stainless steel screws
• odour trap with swivel elbow
• bowden waste control
• flexible overflow pipe
• side G1/2" fitting for filling of pre-mixed water
• length of bath waste trap 57 cm

Technical properties

• odour trap 50 mm
• flow rate 48,6 l/min
• overflow flow rate 33,6 l/min
• 588 Pa pressure resistance of odour trap
• 95 °C thermal resistance

Scope of supply

• waste trap body with overflow
• metal control knob with matte black finish
• metal plug with matte black finish
• brass waste grid strainer with matte black finish
• polypropylene odour trap, thermally and chemically resistant, longitudinally welded
• assembly kit
• adjustable gasket